Apollo Intelligent Meter Series IMY Manuale Utente Scaricare il pdf (Pagina 36)

ANALOG OUTPUT CALIBRATION

Although the analog output has been calibrated at the factory, zero and

span adjustments are provided to compensate for small offsets and drifts. If

excessive drift is noticed, the following calibration procedure may be

performed.

Scale the analog output by entering an arbitrarily larger display value for

“AN-HI” then for “AN-LO”, in “PRO 8”.

Note: Set the analog output source assignment for input.

4 to 20 mA Calibration

Exit the programming mode and apply a (temperature)/(resistance) to the

input of the indicator so that the display reading is below that of the value

entered for “AN-LO”. Adjust the zero potentiometer (right side) so that

exactly 4.00 mA flows, as verified by an accurate ammeter. Next, apply a

(temperature)/ (resistance) to the indicator so that the display reading is

above that of the value entered for “AN-HI”. (See Appendix “B” for max.

input voltage.) Adjust the span potentiometer (left side) so that 20.00 mA is

flowing. Repeat the zero and span adjustments until both are accurate. Analog

output calibration is complete.

0 to 10 VDC Calibration

Exit the programming mode and apply a (temperature)/(resistance) to the

input of the indicator so that the display reading is below that of the value

entered for “AN-LO”. Adjust the zero potentiometer (right side) so that exactly

0.00 VDC flows, as verified by an accurate voltmeter. Next, apply a

(temperature)/ (resistance) to the input of the indicator so that the display

reading is above that of the value entered for “AN-HI”. (See Appendix “B” for

max. input voltage.) Adjust the span potentiometer (left side) so that 10.00

VDC is flowing. Repeat the zero and span adjustments until both are accurate.

Analog output calibration is complete.

-34-

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Nessun commento

Apollo Intelligent Meter Series IMY Manuale Utente Pagina 36